Minikom amplifier MATV 4E/1S "EasyF" FM-VHF-UHF-UHF - TELEVES 562422

Configurable headend amplification center for MATV systems with separate amplification that guarantees the absence of intermodulation between inputs.
It has 4 inputs: FM-VHF-UHF-UHF, VHF and UHF have both margins of selectable gain while the FM input has a single amplifier stage.
It has a switch for selecting an LTE790 or LTE700 anti filter, and a signal indicator LED on the output for immediate detection of network failures.

It stands out by
- Very compact size (103x103x 50mm)
- Switch for LTE filter selection (790/700 ), to eliminate telephony interference
- LEDs indicating the existence of signal in output and power
- Configurable gain through a switch (high/low) and high output level
- Two amplification stages for the TV bands
- Switched power supply that guarantees low consumption
- EasyF Connection System
- High-blind chassis agem, made in Zamak

Main characteristics
- Test output (-30dB)
- Intuitive front character, with adjustments and Block diagram
- Switch ON/OFF to pass DC through the VHF and UHF inputs, for powering preamps or BOSS systems
- Screws into the wall

Discover
EasyF connection system: simplicity and savings
The EasyF system is an innovative concept for connecting the central conductor of the coaxial cable (live), with direct connection to the device increasing the reliability of the connection. The absence of "F" connectors makes it possible to reduce the chassis and connect two coaxial cables in the same compartment.

- Real time savings: significantly reduces installation time as there is no need to apply connectors. It also has the advantage of space, avoiding the process of tightening the connectors that complicates when it is reduced
- Connection reliability: The clamp that supports the cables prevents them from coming loose
- Economical: no needs additional connectors ("F" or "CEI")
- Space optimization: inputs and outputs are always on the same side of the device, avoiding creasing coaxial cables and facilitating work inside cabinets and boxes
- Very simple assembly in just three steps: It only requires opening and screwing the clamp to connect the cables:

1. Open the clamp
2. Insert the cables previously stripped coaxials
3. Close and tighten the clamp to secure the connection

More information about the reliability of the EasyF system
With EasyF, the connection of the coaxial cable to the device is carried out through an automatic system of insertion of the live, (central conductor) by contact, without the need for welding.

- Durability: the lifetime of the device increases by eliminating solders that deteriorate over time
- Reduction of the failure rate: usually caused by cold solders
- Optimization of electromagnetic behavior: at high frequencies
- Commitment to the environment: contamination caused by the welding process is eliminated and electrical consumption associated with the manufacturing process is reduced